Input voltage: DC5V
Max current draw : 60mA per RGB LED
IC Model: APA-102C
LED Qty: 30 LEDs/M, 150 LEDs/Roll
FPC width: 10mm
Length: 5 meter a roll
Light source: Epistar 5050 SMD LEDs
Beam angle: ~120°
LED Brightness: Red ~600mcd, Green ~500mcd, Blue ~150mcd
Protection rate：Non-waterproof or IP67 waterproof (sealed in silicone tube)
FPCB color: BLACK
Click here to check the datasheet of APA102
Besides the 30 LEDs/M version of APA102 strips, we have 144 LED/m, 60 LED/m versions.
Unlike WS2812B LED strip, The APA102 led strip has 2 wires for sending data - one clock pin and one data pin. That means you need two pins, not one, to control strip. Because the clock and data is seperated, you can use any processor speed or type to control these strips. You can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. It's very easy to port the library, and you can send data to the pixels at up to 32MHz clock rate!
Every LED section can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.
You may also be interested in the following product(s)
Regular Price: $127.00
Special Price: $94.50
Regular Price: $53.00
Special Price: $39.50