SK6813HV-09-6P 12V Digital RGB 5050 LED, Dual-signal Transmission, Full Reel of 1000
12V operating voltage instead of the usual 5V. This reduces the current to approximately 33% for the same power, simplifying the circuit routing and reducing the required cable cross-sections. Furthermore, operation is more energy-efficient.
The LEDs can be easily and very tightly placed on single-layer boards.
The SK6813HV has a backup data line for this case, and the defective LED is simply "skipped" if no data is detected on the main line. Therefore, two cables are required to cabling the data.
We have them straight off the factory floor in full reels of 1,000 LEDs packed in the aluminum envelop.
- Buy 10 for $125.50 each and save 16%
- Buy 30 for $115.50 each and save 23%
- Buy 50 for $105.50 each and save 29%
- Buy 100 for $99.50 each and save 33%
SK6813HV-09-6P is a smart LED control circuit and light emitting circuit in one controlled LED source, which has the shape of a 5050 LED chip. Each lighting element is a pixel, and the intensities of the pixels are contained within the intelligent digital interface input. The output is driven by patented PWM technology, which effectively guarantees high consistency of the color of the pixels. The control circuit consists of a signal shaping amplification circuit, a built-in constant current circuit, and a high precision RC oscillator.
The data protocol being used is unipolar RZ communication mode. The 24-bit data is transmitted from the controller to DIN of the first element, and if it is accepted it is extracted pixel to pixel. After an internal data latch, the remaining data is passed through the internal amplification circuit and sent out on the DO port to the remaining pixels. The pixel is reset after the end of DIN. Using automatic shaping forwarding technology makes the number of cascaded pixels without signal transmission only limited by signal transmission speed.
