12V WS2815 5050 RGB LED, Dual-signal Transmission, 100 Pack
12V individually addressable with Breakpoint continuous transmission function
Serial cascade interface, data receiving and decoding depend on just one signal line.
We have them straight off the factory floor in full reels of 1,000 LEDs packed in the aluminum envelop. If you are the person who needs that many, we highly recommend to buy them by reels to keep moisture to the minimum. Ordering 10 packs (1,000 LEDs) at a time, you will get a whole reel.
- Buy 10 for $12.55 each and save 16%
- Buy 50 for $11.55 each and save 23%
- Buy 100 for $10.55 each and save 29%
- Buy 500 for $9.55 each and save 36%
WS2815B-V3 is an intelligent control LED light source that the control circuit and RGB chip are integrated in a package of 5050 components. Its internal includes intelligent digital port data latch and signal reshaping amplification drive circuit. Dual-signal wires version, signal break-point continuous transmission. Any pixel’s failure won't affect signal transfer and total emitting effect.
The data transfer protocol use single NZR communication mode. After the pixel power-on reset, the DIN port receive data from controller, the first pixel collect initial 24bit data then sent to the internal data latch, the other data which reshaping by the internal signal reshaping amplification circuit sent to the next cascade pixel through the DO port. After transmission for each pixel, the signal to reduce 24bit. Every pixel adopts auto-reshaping transmit technology, making the pixel cascade numbers are not limited to the signal transmission, only relate to the speed of signal transmission.
The BIN receives the data signal, and then compare the data with the DIN side after phagocytosis of 24bit data, if DIN do NOT receive the signal, then switching to BIN for receiving the input signal, which ensure that any the IC's damage
does not affect the signal cascade transmission and make the BIN in state of receiving signal until restart after power-off.
Refresh Frequency updates to 2KHz, Low Frame Frequency and no Flicker appear in HD Video Camera.
RESET time>280μs, it won’t cause wrong reset while interruption, it supports the lower frequency and inexpensive MCU.
Integrated circuit chips enable the circuit control simpler, neater and more reliable while NO extra components needed.
Mechanical Dimensions (mm)