24-18 AWG Single/Two Wire Snap Down T Splice Connector, Pack of 10
- Buy 5 for $5.75 each and save 3%
- Buy 10 for $5.45 each and save 8%
- Buy 50 for $4.95 each and save 17%
Type: Terminal Splice Tap
Max Amperage: 10A
Rated Voltage: 300v
Peak Voltage: 2.5kV
Size: 12.8*25*6.6mm(single channel), 16.6*25*6.6mm(dual channel)
Gauge: 18 /20 /22 /24
Connector Shape: T
Housing material: Polycarbonate
These non-weatherproof, insulated wire splice connectors are designed for 24-18 gauge wire and have a secure snap closure to hold wires in place. Great for adding wires to an existing installation or starting a new one. Rated for 10 Amps at 300V AC/DC.
How to connect:
1. Open the top tray that has four-hole openings
2. Place wire appropriately on the guides inside the tray so it runs through both sides of the top of the connector
3. Push down the tray so it closes with the wires still in the correct position
4. Using pliers, press hard on the top of the closed connector to secure the wire in place and snap the tray closed
5. Open the bottom of the connector
6. Prepare wires to be inserted into the bottom of the connector by cutting it flush with the wire casing
7. Insert wire into the connector and make sure that the wire is pushed all the way to the back of the connector (critical step)
8. Once you have confirmed that the wire has been pushed all the way to the back and is lined up correctly press the connector tray down with pliers to secure the connection
Note: Some 18-gauge wire has extra insulation; for best results, strip back the wire before inserting it into the wire splice connector.