APA102 Digital Addressable RGB LED Strip, 60 LEDs/M, 5V, 5m

APA102 Digital Addressable RGB LED Strip, 60 LEDs/M, 5V, 5m

APA102 Digital Addressable RGB LED Strip, 60 LEDs/M, 5V, 5m

Special Price $89.50 Regular Price $95.00
In stock
SKU
LLH-APA102-60
Overview
Come in 5 meter reels with a 4-pin JST SM connector on each end, 5V DC input, 60 LED per meter. Each LED can be cut.
  • Buy 5 for $85.50 each and save 4%
  • Buy 10 for $79.50 each and save 11%
  • Buy 30 for $75.50 each and save 16%

Input voltage: DC5V
Max current draw : 60mA per RGB LED
IC Model: APA-102C 
LED Qty: 60 LEDs/M 
FPC width: 12mm
Length: 5meter a roll
Pixel pitch: 16.65mm / 0.65" between LEDs
Light source: Epistar 5050 SMD LEDs
Beam angle: ~120°
LED Brightness: Red ~600mcd, Green ~500mcd, Blue ~150mcd
Protection rate: Non-waterproof  or IP67 waterproof (sealed in silicone tube)
Finish(PCB Color):white or Black available
FPCB color: BLACK 

Click here to check the datasheet of APA102

Besides the 60 LEDs/M version of APA102 strips, we have 144 LED/m, 30 LED/m versions. 

Unlike WS2812B LED strip, The APA102 led strip has 2 wires for sending data - one clock pin and one data pin. That means you need two pins, not one, to control strip. Because the clock and data is seperated, you can use any processor speed or type to control these strips. You can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. It's very easy to port the library, and you can send data to the pixels at up to 32MHz clock rate!

Every LED section can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.  

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
We found other products you might like!