APA102 Digital Addressable RGB LED Strip, 5V, 144/m, 60/m, 30/m Available

APA102 Digital Addressable RGB LED Strip, 5V, 144/m, 60/m, 30/m Available

APA102 Digital Addressable RGB LED Strip, 5V, 144/m, 60/m, 30/m Available

Special Price $36.50 Regular Price $43.00
In stock
SKU
LLH-APA102-144/60/30
Overview

Comes with a 4-pin JST SM connector on each end, 5V input, Each LED can be cut.

  • Buy 5 for $33.50 each and save 8%
  • Buy 10 for $31.00 each and save 15%
  • Buy 50 for $29.50 each and save 19%

Input voltage: DC5V
Max current draw : 60mA per RGB LED
Control signal: APA102
LED Density: 30, 60,144leds/Meter Available
Pixels : 30, 60, 144/Meter
Power: 9W/m (30LED/m), 18W/m(60LED/m),43.2W/m(144LED/m)
Grey scale: 256
Bits/color: 8-bits/color;total 24bit for RGB color
LED wavelengths: 630nm/530nm/475nm
Cuttable: every LED is cuttable
FPC width: 12mm (144leds/m), 10mm (30leds/m and 30leds/m type)
Finish (PCB color): white/black
Length: 5 meter reel for 30LED/m type, 5 meter reel for 60LED/m type, 1 m reel for 144LED/m type
Protection rate: Non-waterproof or IP67 waterproof (sealed in silicone tube)

Unlike WS2812B LED strip, The APA102 led strip has 2 wires for sending data - one clock pinand one data pin. That means you need two pins, not one, to control strip. Because the clock and data is seperated, you can use any processor speed or type to control these strips. You can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. It's very easy to port the library, and you can send data to the pixels at up to 32MHz clock rate!

Every LED section can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.  

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
We found other products you might like!