APA102 Warm White/Cool White Digital Intelligent LED Strip, 144LED/m, 5V
- Buy 5 for $39.50 each and save 9%
- Buy 10 for $37.50 each and save 14%
- Buy 50 for $35.00 each and save 20%
Input voltage: DC5V
Max current draw : 60mA per LED
IC Model: APA-102C
Light source: Epistar 5050 SMD LEDs
Color: Warm White 2800-3200K, Cool White 6000-6500K
LED Qty: 144 LEDs/M
FPC width: 12mm
Length: 1 meter a roll
Beam angle: ~120°
Protection rate: Non-waterproof or IP67 waterproof (sealed in silicone tube)
FPCB color: White
Click here to check the datasheet of APA102
Unlike WS2812B LED strip, The APA102 led strip has 2 wires for sending data - one clock pin and one data pin. That means you need two pins, not one, to control strip. Because the clock and data is seperated, you can use any processor speed or type to control these strips. You can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip. It's very easy to port the library, and you can send data to the pixels at up to 32MHz clock rate!
Every LED section can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.