DMX RGB LED Strip, Pixel-by-Pixel Direct DMX Control, 60 Pixels/m, 12V, 5m
Parallel DMX signal, avoiding all lights influenced by the failure of one light in serial connection.
It comes in 5meters per reel with a 4Pin JST SM connector on both end and separated Power / Ground Wires.
Input voltage: DC12V
Power consumption: 14.4W/m max
LED Qty: 60 pcs RGB 5050 LEDs per meter
IC Chip: DMX512 full color
Pixel Qty: 60 pixels/m
PCB Size: L5000*W12*H2.5(mm)
View angle: 120 degree
Protection rate: Non-waterproof or IP67 waterproof (sealed in silicone tube)
Finish: white
With standard DMX512 protocol, this strip is compatible with Artnet and Madrix, supporting numerous color-change effects. The strip comes with five wires, +12V, PI address writing wire, Date, GND, respectively, and can be controlled directly via DMX controller without using decoders.