Mini Wireless SP103E RF Controller
Functions Of Each Button:
ON/OFF: To control the LED ON or OFF
MODE+: Switching patterns forwardly
MODE-: Switching patterns backwardly
SPEED+: Switching speed forwardly
SPEED-: Switching speed backwardly
AUTO: Run internal pattern automatically
NUM+: Add the number of pixels on each section
NUM-: Decreased the number of pixels on each section
SEC+: Add number of section.
SEC-: Decreased number of section.
MATCH: Match the Remote control with the receiving controller
How to Use:
Testing: Continuously pressing the AUTO button 5 times until LED is out, release the AUTO button to into the mode of switch ing in red,green,blue,yellow,purple,cyan and white,witch to test the your LED.
Matching: Continuously pressing the MATCH button 5 times until LED flash in white quickly to match the Remote control with the receiving controller.Pressing the MATCH button for 5 times till LED flash in white slowly to un-match;
Reorder RGBW: Differ from kinds of LED, The R G B W keys may don’t perfectly match to your LED,Reorder them if needed. Continuously pressing the SETTING button 5 times until LED flash in white once and then turn into all white,Pressing the R button until LED is red, Pressing the G button until LED is green, pressing the B button untill LED is blue, pressing the W button untill LED is White, then press the SETTING button once to confirm your setting;
Adjust Num of pixels: The factory default setting of the number of controlled pixel is 600. Continuously pressing the SETTING button 5 times until LED flash once and turn all white, pressing MODE+ to add pixels ,pressing MODE- to decrease pixels,(each pressing add or decrease 60 pixels) then press the SETTING button to confirm your setting;Can be regulated to up to 2048 pixels,The minimum number is 300 pixels.
Catching: When in the AUTO mode, pressing the SETTING button once,and then press MATCH button once to catch the Current pattern to stay and operate circularly.