SK9822 Digital Addressable RGB LED Strip, 5V, 144/m, 60/m, 30/m Available
SK9822, CLK+Data double wire transfer
Comes with a 4-pin JST SM connector on each end, 5V input, Each LED can be cut.
For B2B or Large Quantity Price Info, Please email us.
- Buy 5 for $29.50 each and save 14%
- Buy 10 for $28.50 each and save 17%
- Buy 20 for $27.50 each and save 20%
Input voltage: DC5V
Max current draw : 60mA per RGB LED
Control signal: SK9822
LED Density: 30, 60,144leds/Meter Available
Pixels : 30, 60, 144/Meter
Power: 9W/m (30LED/m), 18W/m(60LED/m),43.2W/m(144LED/m)
Grey scale: 256
Bits/color: 8-bits/color;total 24bit for RGB color
LED wavelengths: 630nm/530nm/475nm
Cuttable: every LED is cuttable
FPC width: 12mm (144leds/m), 10mm (30leds/m and 30leds/m type)
Finish (PCB color): white/black
Length: 5 meter reel for 30LED/m type, 5 meter reel for 60LED/m type, 1 m reel for 144LED/m type
Protection rate: Non-waterproof or IP67 waterproof (sealed in silicone tube)
Similar to APA102 LED strip, the SK9822 led strip has 2 wires for sending data - one clock pin and one data pin. That means you need two pins, not one, to control strip. Because the clock and data is seperated, you can use any processor speed or type to control these strips. You can use any microcontroller or microprocessor, including Arduino, Raspberry Pi, BeagleBone, Propeller, SparkCore, and any 'raw' microcontrollers/microprocessors to control the strip.
This strip comes as a single full meter with a 4-pin JST SM connector on each end. Every LED segment can be cut. Solder to the 0.1" copper pads and you're good to go.you can also connect strips together to make them longer. To power this strip, you need 5V power supply.
