60/m WS2813 Digital RGB LED Strip, Dual Data Signals, 5V, 5m

60/m WS2813 Digital RGB LED Strip, Dual Data Signals, 5V, 5m

60/m WS2813 Digital RGB LED Strip, Dual Data Signals, 5V, 5m

Special Price $79.50 Regular Price $87.00
In stock
Come in 4 meter reels with a 4-pin JST SM connector on each end, 5V DC input, 60 LED per meter. Dual-signal wires, 1 integrated RGB LEDs per segment, individually controllable.
  • Buy 5 for $73.50 each and save 8%
  • Buy 10 for $69.50 each and save 13%
  • Buy 30 for $65.50 each and save 18%

LED resource: A-quality WS2813 integrated RGB LED
Input voltage: DC5V
Max current draw: 60mA per RGB LED
Qty of LED:  60leds/meter
Grey scale: 256
Bits/color: 8-bits/color;total 24bit for RGB color
LED wavelengths: 630nm/530nm/475nm
Cuttable: every LED is cuttable
Length: 5 meter roll, sold by roll
Finish(PCB Color):white or Black available
FPC width: 10mm
Protection rate: Non-waterproof  or IP67 waterproof (sealed in silicone tube) 

Pls click here to check the detailed datasheet of WS2813 integrated RGB LED

Besides the 60 LEDs/M density of WS2813 strip, we also have 144 LED/m (1m roll)30 LED/m (5m roll) density availabe. 

WS2813 is an intelligent control LED light source that the control circuit and RGB chip are integrated in a package of 5050 components. Its internal include intelligent digital port data latch and signal reshaping amplification drive circuit. Also include a precision internal oscillator and a 12V voltage programmable constant current control part, which achieves highly consistent color effect.

The data transfer protocol use single NZR communication mode. After the pixel power-on reset, the DIN port receive data from controller, the first pixel collect initial 24bit data then sent to the internal data latch, the other data which reshaping by the internal signal reshaping amplification circuit sent to the next cascade pixel through the DO port. After transmission for each pixel, the signal to reduce 24bit. Every pixel adopts auto-reshaping transmit technology, making the pixel cascade numbers are not limited to the signal transmission, only relate to the speed of signal transmission.

The BIN receives the data signal, and then compare the data with the DIN side after phagocytosis of 24bit data, if DIN do NOT receive the signal, then switching to BIN for receiving the input signal, which ensure that any the IC's damage does not affect the signal cascade transmission and make the BIN in state of receiving signal until restart after power-off.

Refresh Frequency updates to 2KHz, Low Frame Frequency and no Flicker appear in HD Video Camera.250us or more of reset time, it won’t cause wrong reset while interruption, it supports the lower frequency MCU.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
We found other products you might like!